grand dink 125 mmc 1 Werkstatthandbuch : Seite 191

          14.STEERING HANDLEBAR/FRONT WHEEL/FRONT
   BRAKE/FRONT SHOCK ABSORBER/FRONT FORK                                GRAND DINK 125/150


                                                       Brake Master Cylinders
 STEERING HANDLEBAR
 REMOVAL
 Remove the handlebar front and rear covers.
 ( 2-6)
 Remove the front and rear brake master
 cylinder attaching bolts.
 Remove the front upper cover. ( 2-5)
 Remove the front lower cover. ( 2-5)
 Remove the floor board. ( 2-4)
 Remove the leg shield. ( 2-5)
                                                                        Bolts
                                                                                Throttle Grip
 Remove the four screws attaching the right
 and left handlebar switches.
 Disconnect the throttle cable from the throttle
 grip and remove the throttle grip from the
 handlebar.




                                                   Screws                       Throttle Cable

                                                                 Bolt
 Remove the handlebar lock nut and take out
 the bolt.
 Remove the handlebar.




                                                            Lock Nut
                                                               Bolt
 INSTALLATION
 Install the handlebar onto the steering stem
 and install the handlebar collar, lock nut and
 bolt.
 Tighten the bolt to the specified torque.
 Torque: 39.249N-m




                                                                          Collar

                                                                                         14-4