grand dink 125 mmc 1 Werkstatthandbuch : Seite 194

          14.STEERING HANDLEBAR/FRONT WHEEL/FRONT
   BRAKE/FRONT SHOCK ABSORBER/FRONT FORKGRAND DINK 125/150

                                                  Driver Handle
 Pack all bearing cavities with grease.
 Drive in the left bearing.
 Install the distance collar.
 Drive in the right bearing.
 · Do not allow the bearings to tilt while
      driving them in.
    · Drive in the bearing squarely with the
      sealed end facing out.
 Special Tools
 Outer driver                                       Outer Driver
 Driver handle
                                                                   Speedometer Gear Unit

 INSTALLATION
 Apply grease to the speedometer gear unit.
 Install the speedometer gear unit by aligning
 its retaining pawl with the hub cutout.
 · If not aligned, the retaining pawl will
      be deformed when the axle nut is
      tightened.
    · After installing the axle, turn the wheel
      to make sure that the speedometer drive
      shaft rotates freely.                       Hub Cutout       Pawl
                                                                              Tab
 Install the front wheel by aligning the
 speedometer gear unit groove with the front
 shock absorber tab.
 Insert the axle and tighten the axle nut.
 When installing the front wheel, position
    the brake disk between the two brake
    pads.
 Torque: 44.149N-m

                                                  Speedometer Gear Unit     Groove




14-7