grand dink 125 mmc Werkstatthandbuch : Seite 195

          14.STEERING HANDLEBAR/FRONT WHEEL/FRONT
   BRAKE/FRONT SHOCK ABSORBER/FRONT FORK                                  GRAND DINK 125/150


                                                             Bolts                 Holder
 FRONT BRAKE
 BRAKE MASTER CYLINDER
 REMOVAL
 Remove the handlebar covers. ( 2-6)
 First drain the brake fluid from the hydraulic
 brake system.
 Disconnect the front stop switch wire
 connector.
 Remove the brake fluid tube bolt.
 Remove the two bolts attaching the brake
 master cylinder                                                    Stop Switch Wire Connector
 Remove the brake master cylinder.
 · When servicing the brake system, use
     shop towels to cover rubber and plastic
     parts and coated surfaces to avoid
     being contaminated by brake fluid.
   · When removing the brake fluid tube
     bolt, be sure to plug the tube end to
     avoid brake fluid leakage.




                                                                    Snap Ring
 DISASSEMBLY
 Remove the brake lever bolt and the brake
 lever.
 Remove the piston rubber cover and snap
 ring from the brake master cylinder.




                                                           Snap Ring Pliers (Close)
                                                  Master Cylinder       Spring        Main Piston
 Remove the washer, main piston and spring
 from the brake master cylinder.
 Clean the inside of the master cylinder and
 brake reservoir with brake fluid.




                                                        Snap Ring             Rubber Cover

                                                                                          14-8