kxr maxxer 250 300 Werkstatthandbuch : Seite 168

          13. BRAKE SYSTEM                                                                ATV 300/250


                                                                 Brake Pad Cover        Cotter Pin
 REAR HYDRAULIC BRAKE
 REAR BRAKE PADS REMOVAL
 Remove the brake pads cover.
 Remove the cotter pin and then pull out the
 brake pad pin from the caliper.




                                                                Brake Pad Pin
 Remove the brake spring plate and then                                       Brake Pads
 remove brake pads.




                                               Spring Plate


 INSTALLATION                                                    Spring Plate Big End
 Reverse the "REAR BRAKE PADS
 REMOVAL" procedures.
 · Make sure put the spring plate big end
     on the rear caliper.
   · Make sure put the spring plate small
     end on the rear pads.
   · Make sure brake pad pin over the
     spring plate.

                                               Brake Pad Pin        Spring Plate Small End
 REAR BRAKE FLUID                                                         Reservoir Cover (Pedal)
 CHANGE/AIR BLEED
 BRAKE FLUID DRAINING
 Place the machine on the level ground.
 Remove the two screws attaching the brake
 fluid reservoir cap (brake lever and brake
 pedal).

    Use shop towels to cover plastic parts
    and coated surfaces to avoid damage
    caused by splash of brake fluid.
                                               Reservoir (Front Left Lever)

13-11