14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM ATV 300/250
Install the distance collar. Distance Collar
Be sure the tapered side of the distance
collar face the wheel.
Install the right new bearing and dust seal
into the front wheel hub.
Apply the grease onto the oil seal lips,
bearing.
Special tool:
Oil seal and bearing install E014
· Do not allow the bearings to tilt while
driving them in.
· Do not strike the center race or balls of
the bearing. Contact should be made
only with the outer race.
· Pack all bearing cavities with grease.
· Drive in the bearing squarely with the
sealed end facing out.
INSTALLATION
Reverse the "FRONT WHEEL HUB
REMOVAL AND INSPECTION"
procedures.
Apply grease onto the bearing and dust
seal lips of the wheel panel.
Tighten the front wheel hub nut.
Torque: 7 kgf-m (70 N-m, 50 lbf-ft)
14-6
Sehr seriöser Verkäufer, zu empfehlen 
4.7 / 5