14. FRONT WHEEL/FRONT SUSPENSION/ STEERING SYSTEM ATV 300/250 INSTALLATION Holder Surface Install handlebar and handlebar holder, then tighten the four bolts. Torque: 2.3 kgf-m (23 N-m, 16.56 lbf-ft) · Align the mark on the handlebar with the lower handlebar holder surface. · Be sure the upper handlebar holder mark face to front. · Fist tighten the bolts on the front side of the handlebar holder, and then Mark tighten the bolts on the rear side. Forward Mark Install the handlebar switch by aligning the Hole pin on the handlebar switch with the hole in the handlebar and then tighten the two screws. Pin "UP" Mark Place the right and left brake master cylinder on the handlebar and install the master cylinder holder with the "UP" mark facing up, aligning the punch mark on the handlebar with the holder joint seam. First tighten the upper bolt and then tighten the lower blot. Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft) Punch Mark Joint Seam 14-16