kxr maxxer 250 300 Werkstatthandbuch : Seite 49

          3. INSPECTION/ADJUSTMENT                                                  ATV 300/250


 ENGINE OIL REPLACEMENT AND
 OIL FILTER CLEANING
 Place the machine on a level place.
 Warm up the engine for several minutes and
 stop it.
 Place a container under the engine.
 Remove the oil fill cap and oil filter cap to
 drain the oil.

 Clean the oil strainer with solvent.
 Inspect the O-ring and replace if damaged.          Oil Filter Cap
 Reinstall the O-ring, oil strainer,
 compression spring and oil filter cap.              Compression Spring           O-ring
 Tighten the oil filter cap to specification.
 Torque: 1.5 kgf-m (15 N-m, 11 lbf-ft)

 Fill the engine with oil and install the oil fill
 cap.
 Oil Capacity:
 At disassembly:
                1.6 liter (1.4 lmp qt, 1.7 Us qt)
 At change: 1.4 liter (1.23 lmp qt, 1.48 Us
 qt)
                                                     Oil Strainer         Oil Filter Cap

                                                     Oil Filler Bolt
 TRANSMISSION OIL
 REPLACEMENT
 Place the machine on a level place.
 Place a container under the engine.
 Remove the oil filler bolt and drain plug to
 drain the oil.
 Reinstall the drain plug and tighten to
 specification.
 Torque: 2 kgf-m (20 N-m, 15 lbf-ft)

 Fill the engine with oil and install the oil
 filler bolt.                                         Drain Plug
 Oil Capacity:
 At disassembly:
              400 cc (0.35 lmp qt, 0.42 Us qt)
 At change: 300 cc (0.26 lmp qt, 0.32 Us qt)
 Start the engine and warm up for a few
 minutes. While warming up, check for oil
 leakage. If oil leakage is found, stop the
 engine immediately and check for the cause.
 Make sure that the sealing washer is in
   good condition.


                                                                                   3-10