1. Kymco
  2. Werkstatthandbuch
  3. kxr maxxer 250 300 Werkstatthandbuch
  4. Seite 55

kxr maxxer 250 300 Werkstatthandbuch : Seite 55

Microfiches
Image preview

Seite 53

Image preview

Seite 54

Image preview
Image preview

Seite 56

Image preview

Seite 57

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 249 
          3. INSPECTION/ADJUSTMENT                                                     ATV 300/250


 DRIVE CHAIN SLACK
 ADJUSTMENT
 Before checking and/or adjusting, rotate the
 rear wheels several revolutions and check
 slack at several points to find the tightest
 point. Check and/or adjust the chain slack
 with the rear wheels in this "tightest"
 position.
 Too little of chain slack will overload the
    engine and other vital parts; keep the
    slack within the specified limits.

 Place the machine on a level place.
 Wheels should be on the ground without
    the rider on it.

 Check drive chain slack.
 Adjust if out of specification.
 Drive chain slack (A):
                     30 ~ 40 mm (1.2~1.6 in)




 Adjust drive chain slack:                        Bolt        Bolts
 Loosen the caliper holder bolt and two axle
 hub holding bolt.




                                                           Driven Sprocket        Pin
 Provide a proper pin and pass the pin
 through the axle hub and driven sprocket.




                                                Axle Hub



                                                                                  3-16
 Microfiches.net - Ersatzteilkataloge anderer Marken