1. Kymco
  2. Werkstatthandbuch
  3. mxu 250 300 2 Werkstatthandbuch
  4. Seite 305

mxu 250 300 2 Werkstatthandbuch : Seite 305

Microfiches
Image preview

Seite 303

Image preview

Seite 304

Image preview
Image preview

Seite 306

Image preview

Seite 307

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 352 
          15. REAR WHEEL/AXLE/SUSPENSION/
     DRIVING MECHANISM                                                          MXU 300/250

                                                                     Lock Nut
 Install a new lock nut and tighten it to the
 specified torque using the special tools.

 Special tool:
 Lock nut wrench          F015

 Torque: 100 N-m (10 kgf-m, 72 lbf-ft)




                                                   Lock Nut Wrench

                                                      Oil Seal
 Apply grease to a new oil seal lips and
 install it into the gear case until it is fully
 seated.




 FINAL GEAR CASE (MXU 300)
 ASSEMBLY

   When the gear set, bearing, and/or gear
   case has been replaced, check the tooth
   contact pattern (page 15-30) and gear
   backlash (page 15-26).


 Clean the mating surface of the gear case
 and cover, being careful not to damage
 them.

   Keep dust and dirt out of the case and
   cover.

 Blow compressed air through the breather
 hole in the gear case.

                                                                                   15-36
 Microfiches.net - Ersatzteilkataloge anderer Marken