1. Kymco
  2. Werkstatthandbuch
  3. mxu 250 300 2 Werkstatthandbuch
  4. Seite 352

mxu 250 300 2 Werkstatthandbuch : Seite 352

Microfiches
Image preview

Seite 348

Image preview

Seite 349

Image preview

Seite 350

Image preview

Seite 351

Image preview
1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 352 
          19. LIGHTS/SWITCHES                                                   MXU 300/250


 NEUTRAL/REVERSE
 SWITCHES
 INSPECTION
 Disconnect the neutral/reverse switch wire
 connector. (See page 6-4 or 6-10)

 Check for continuity between the switch
 side connector terminal and engine ground.

 NEUTRAL SWITCH
 There should be continuity with the
 transmission in neutral and no continuity
 with it in any gear except neutral.

 REVERSE SWITCH
 There should be continuity with the
 transmission in reverse and no continuity
 with it in any gear except reverse.


                                                Set Plates   Neutral/Reverse Switch
 REPLACEMENT
 Remove drive and driven pulley. (Refer to
 chapter 9)

 Remove the two bolts and set plates.
 Remove neutral/reverse switch.




                                                             Bolts


                                                                             O-ring
 Install a new switch with a new O-ring
 (apply engine oil to O-ring).
 Make sure that the lever on the
   neutral/reverse switch correctly engages
   with the locating slot on the shift shaft.




                                                                     Lever



19-7
 Microfiches.net - Ersatzteilkataloge anderer Marken