11. FRONT WHEEL/SUSPENSION/ STEERING Pulsar CK 125 Remove the four upper fork bridge bolts to remove the handlebar. Bolts INSTALLATION Upper Fork Bridge Set Plates Place the handlebar on the upper fork bridge seat, aligning the punch mark on the handlebar with the top of the upper fork bridge seat. Install the upper fork bridge set plates onto the handlebar. First tighten the front bolts and then the rear bolts. Torque: 0.91.3kg-m Upper Fork Bridge Seat Hole Set the left handlebar switch housing on the left handlebar and align the pin on the housing with the hole in the handlebar. Tighten the two switch housing screws. Holder Pin Place the front brake master cylinder on the Master Cylinder handlebar with the master cylinder holder "UP" mark facing up. Also, align the punch mark on the handlebar with the holder joint seam. First tighten the upper bolt and then the lower bolt. Torque: 1.01.4kg-m Holder Bolts 11-4