new pulsar 125 Werkstatthandbuch : Seite 96

          10.CRANKCASE/CRANKSHAFT/TRANS-
   MISSION SYSTEM/STARTER SPINDLE                                                Pulsar       CK   125
                                                           A
 STARTER SPINDLE INSPECTION
 Inspect the starter spindle for wear or
 damage.
 Measure the starter spindle O.D.
 Service Limits:
     A: 15.95mm replace if below
     B: 19.95mm replace if below
     C: 11.95mm replace if below
                                                    Starter Spindle                       B         C


 BEARING INSPECTION                                                   Play                                Play
 Check the main shaft and countershaft
 bearings for smooth turning. Replace the
 bearings with new ones if they do not turn
 smoothly, quietly, or if they fit loosely in the
 case.
 If the countershaft needle bearing in the right
 crankcase is noisy or has excessive free play,                          Axial                            Radial
 replace it with the crankcase as a set.




                                                    Countershaft
 BEARING REPLACEMENT                                Bearing            Right Crankcase        Bearing Remover
 Remove the main shaft and countershaft
 bearings from the left and right crankcase
 halves using the following tools.
  Special

 Bearing Remover             E037




                                                    Main Shaft               Main Shaft       Countershaft
                                                    Bearing                  Bearing          Bearing

 Drive in new bearings using a bearing driver.                                                Crankcase

 · Apply engine oil to the bearings before
      installation.
    · Drive in bearings squarely.

  Special

 Oil seal & Bearing install E014


                                                               Bearing Driver

10-7