14. STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK PEOPLE/PEOPLE S 250 Driver Handle Pack all bearing cavities with grease. Drive in the left bearing. Install the distance collar. Drive in the right bearing. · Do not allow the bearings to tilt while driving them in. · Drive in the bearing squarely with the sealed end facing out. Special Tools Oil seal & bearing installer E014 Outer Driver Pawl Speedometer Gear Unit INSTALLATION Apply grease to the speedometer gear unit. Install the speedometer gear unit by aligning its retaining pawl with the hub cutout. · If not aligned, the retaining pawl will be deformed when the axle nut is tightened. · After installing the axle, turn the wheel to make sure that the speedometer drive shaft rotates freely. Hub Cutout Install the front wheel by aligning the Axle Tab speedometer gear unit groove with the front shock absorber tab. Insert the axle and tighten the axle. When installing the front wheel, position the brake disk between the two brake pads. Torque: 2935N-m Install and tighten the two bolts. Speedometer Gear Unit Groove Torque: 812N-m 14-7