18. STARTING SYSTEM PEOPLE/PEOPLE S 250 Check if the needle bearing in the front cover Bushing turns freely and has no excessive play. Replace if necessary. Check the dust seal for wear or damage. Dust Seal ASSEMBLY Apply grease to the dust seal in the front cover. Install the brushes onto the brush holders. Apply a thin coat of grease to the two ends of the armature shaft. Insert the commutator into the front cover. Motor Case Mark Install a new O-ring to the front cover. Install the starter motor case, aligning the tab on the motor case with the groove on the front cover. Tighten the starter motor case screws. O-ring Motor Case INSTALLATION Starter Motor Cable Connect the starter motor cable. Check the O-ring for wear or damage and replace if necessary. Apply grease to the O-ring and install it to the starter motor. Tighten the two mounting bolts. O-ring 18-5