6. CYLINDER HEAD/VALVES PEOPLE/PEOPLE S 250 Bolts CYLINDER HEAD COVER REMOVAL Remove the met-in box, carrier. ( 2-6) Remove the body cover, center cover and rear fender A. ( 2-6) Disconnect the secondary air inlet tube connector and breather hose (air cleaner). ( 5-2) Remove the cylinder head cover four bolts and two nuts attaching the secondary air inlet duct. Cylinder Head Cover Nuts Remove the cylinder head cover. Bolt CAMSHAFT REMOVAL Turn the A.C. generator flywheel so that the "T" mark on the flywheel aligns with the index mark on the right crankcase cover. Hold the round hole on the camshaft gear facing up and the location is the top dead center on the compression stroke. Remove the cam chain tensioner cap bolt. Cam Chain Tensioner Round Hole Tensioner Screw Turn the cam chain tensioner screw clockwise to tighten it. Remove the two bolts attaching cam chain tensioner and the tensioner. Bolts Cap Nuts First remove the two bolts between the cylinder head and cylinder. Then, remove the four cap nuts and washers on the camshaft holder. · Diagonally loosen the cylinder head cap nuts in 2 or 3 times. Bolts Camshaft Holder 6-4