9. DRIVE AND DRIVEN PULLEYS/ KICK STARTER SUPER8 125 Install the drive pulley face, starting ratchet and drive face nut. Drive Pulley Face · When installing the drive pulley face, compress it to let the drive belt move downward to the lowest position so that the drive pulley can be tightened. · Install the starting ratchet by aligning the starting ratchet teeth with the crankshaft teeth. Hold the drive pulley with the universal Starting Ratchet Drive Face Nut holder and tighten the drive face nut. Torque: 5.5kg-m Drive Pulley Special Flywheel Holder Do not get oil or grease on the drive belt or pulley faces. CLUTCH/DRIVEN PULLEY Flywheel Holder Remove the left crankcase cover. Clutch Outer Remove the drive pulley and drive belt. Hold the clutch outer with the universal holder and remove the clutch outer nut. Special Flywheel Holder INSPECTION Flywheel Holder Inspect the clutch outer for wear or damage. Measure the clutch outer I.D. Service Limit: 125.5mm replace if over 9-7