zing 125 qe Werkstatthandbuch : Seite 83

          9. CLUTCH/GEAR SHIFT MECHANISM                                               ZING II 125



 Installation
 Install the gear shift cam stopper and spring.
 Tighten the 6mm lock bolt.
 Torque: 0.81.2kg-m




                                                                        Gear Shift Cam
 Install the set pin into the transmission drum
 hole.
 Install the gear shift cam, aligning the pin
 hole in the gear shift cam with the set pin.
 Then, tighten the bolt.

 Torque: 0.81.2 kg-m
 · After the gear shift cam is installed, put
      the stopper in the gear shift cam groove
      and tighten the stopper bolt.
    · Rotate the transmission drum to make
      sure that the stopper operates properly.               Gear Shift Cam Stopper




 Install the gear shift spindle and washer.
 During installation, make sure that the return
 spring aligns with the crankcase tab.




                                                  Gear Shift Spindle
                                                                Drive Gear

 Install the oil pump body and insert the pump
 shaft.
 Install the balance shaft drive gear and
 woodruff key onto the crankshaft.
 Install the balance shaft driven gear and
 woodruff key onto the balance shaft.

 Be sure to align the punch marks on the
    drive and driven gears before installing
    the woodruff key onto the balance shaft.
                                                           Pump Shaft

9-7