15. IGNITION SYSTEM Movie S 150i SERVICE INFORMATION .............................. A.C GENERATOR .......................................... TROUBLESHOOTING ................................... TILT SWITCH ........................................... IGNITION COIL .................................................. SERVICE INFORMATION GENERAL INSTRUCTIONS Check the ignition system according to the sequence specified in the Troubleshooting. The ignition system adopts ECU and the ignition timing cannot be adjusted. For ignition inspection, please check one by one based on troubleshooting list. Loose connector and poor wire connection are the main causes of faulty ignition system. Check each connector before operation. Most faulty causes of the connector loosen. Please check all wires to be connected well. Use of spark plug with improper heat range is the main cause of poor engine performance. The inspections in this section are focused on maximum voltage. The inspection of ignition coil resistance is also described in this section. Inspect the ignition switch according to the continuity table specified in page 17-3. Inspect the spark plug referring to Section 3. Remove the A.C. generator and CPS referring to Section 14. SPECIFICATIONS Item Standard Spark plug Standard type CR8E (NGK) Spark plug gap clearance 0.60.7mm Ignition coil resistance (20 C) Primary coil 0.55~0.75 CPS resistance (20 C) 96144