5. FUEL INJECTION SYSTEM MOVIE S 150i CELP FAILURE CODES LIST Failure Blinks Codes Problem Troubleshooting Engine condition (speedo (diagnostic meter) tool) Reset TPI and confirm if the idle position back to within the preset range. Engine running 06 P0120 Faulty TPS Confirm if TPS voltage is within at normal 0.3~4.5 V. Confirm if the connector of TPS is loosen. Change a new TPS. Confirm if MAP voltage is within 1~4.2 V. Engine running 09 P0105 Faulty MAP Confirm if the connector of MAP at normal loosen. Change a new TPS. Confirm if WTS range is near 40°C: Faulty WTS 1.136 Engine running 12 P0115 (water Confirm if the connector of WTS is at normal temperature loosen. sensor) Change a new WTS Confirm if Tilt switch voltage range is below, - incline angle < 65°: 0.4~1.4 V Faulty Tilt Engine running 15 P1630 - incline angle > 65°: 3.7~4.4 V switch (Roll) at normal Confirm if the connector of tilt switch is loosen. Change a new tilt switch Confirm if O2 sensor voltage range is below, - A/F below 14.7: > 0.7V Faulty O2 Engine running 17 P0130 - A/F over 14.7: < 0.18 V sensor's at normal Confirm if the connector of O2 sensor voltage is loosen. Change a new O2 sensor Confirm if Fuel injector range is Faulty within 11.3 10% Engine fail to 33 P0201 injector Confirm if the connector of injector is be started (Nozzle) loosen Change a new injector 5-8