5. FUEL INJECTION SYSTEM MOVIE S 150i O2 SENSOR REMOVAL Disconnect the O2 sensor connector. Remove the bolts attaching the muffler and dismantle the muffler. Apply anti-seize compound on circumference of thread area before installation. Torque: 2.5 kgf-m (25 N-m, 18 lbf-ft) Don't twist the wire when removing the O2 sensor connector. INSPECTION Measure the resistance between each White wire terminals of the O2 sensor side connector. Standard: 6.7 ~ 9.5 Measure the input voltage for the O2 sensor. Disconnect the O2 sensor's connector. The positive terminal connects the pin of harness wire and the negative terminal connects the earth. The figure should be same with battery's voltage. Measure the output voltage for the O2 sensor. Disconnect the O2 sensor's connector. The positive terminal connects the pin of O2 sensor and the negative terminal connects the earth. The figure should be lower than 5V. 5-37