mxu 400 Werkstatthandbuch : Seite 57

          6. Using Magneto Rotor Remover, break the
   rotor/flywheel assembly loose from the crankshaft.
   Remove the remover, the crankshaft protector, the
   rotor/flywheel, and the starter clutch gear. Account
   for the key.

                ! CAUTION
Care must be taken that the remover is fully
threaded onto the rotor/flywheel or damage may
occur.


                                                                                                          MD1305
                                                           8. Remove the gear shift shaft assembly and washer
                                                              from the left-side crankcase. Note the positions of
                                                              the alignment marks and washer for installing pur-
                                                              poses; then release the cam stopper spring tension.




                                                                                                                    3
                                                MD1368




                                                                                                          MD1239
                                                           9. Remove the shift detent cam. Note position of
                                                              spacer for installing purposes.
                                                          10. Remove the cam stopper assembly.
                                                          11. Remove two starter motor cap screws.
                                                MD1369




                                                                                                            KC217

                                                MD1370
                                                          12. Remove starter motor by tapping lightly with a
                                                              mallet.
7. Remove the starter idler gear (No. 1) and starter
   idler gear (No. 2).                                     NOTE: The starter motor is a non-serviceable
                                                          component and must be replaced as an assembly.

                                                          13. Using an impact screwdriver, remove the three
                                                              Phillips-head screws holding the crankshaft bear-
                                                              ing retainer. Remove the crankshaft bearing
                                                              retainer.


                                                                                                            3-27