mxu 400 Werkstatthandbuch : Seite 77

                  11. If the brake pedal was removed during disassem-
            bling, apply grease to the brake pedal pivot stud;
            then install the brake pedal and secure with a flat
            washer and cap screw. Tighten to 20 ft-lb.




KC249




                                                            KC232A




                                                                      3

KC250




                                                            KC149A
        12. Install the heat shield; then install the gas tank (see
            Section 4).
        13. Install the front body panel, front rack, and foot-
            wells (see Section 8).
        14. Pour the appropriate quantity and grade oil into the
            crankcase; then connect the negative battery cable
            and move the ATV outside to a well ventilated
KC251       area.
        15. Start the engine and allow the engine to warm up
            while checking for oil leaks; then shut the engine
            off and check the oil level. Add oil as required.




                                                              3-47