new pulsar 125 Werkstatthandbuch : Seite 116

          11. FRONT WHEEL/SUSPENSION/
    STEERING                                                                Pulsar   CK   125

                                                              Steel Balls        Top Cone Race
 Apply grease to the top and bottom ball races
 and steel balls.
 Install 21 steel balls each on the top and
 bottom ball races.
 Install the steering stem into the steering
 head pipe and then install the top cone race
 and the bearing adjusting nut.




                                                                               Steering Stem



 Tighten the bearing adjusting nut until it
 seats against the top cone race, then turn it
 back 1/8 turn.
 Check that the steering stem rotates
    freely and that there is no vertical play.




                                                 Steering Stem Wrench



 Install the front fork. (Refer to 11-14.)
 Install the upper fork bridge, washer and
 steering stem nut.
 Tighten the steering stem nut.
 Torque: 6.09.0kg-m
 Properly adjust the installed front fork.
 (Refer to 11-14.)


                                                 Lock Nut Wrench, 30x32mm




                                                                                          11-16