mxu 400 Werkstatthandbuch : Seite 129

           2. Inspect the muffler internally by shaking the muf-
    fler back and forth and listening for rattles or loose
    debris inside the muffler.
  NOTE: For additional details on cleaning the muf-
fler/spark arrester, see Section 2.

INSTALLING MUFFLER

 1. Using a new grafoil seal, place the muffler into
    position engaging the mounting lugs into the
    grommets; then slide the muffler forward.
 2. Install the two exhaust springs.                                                                       KC322A
                                                             3. Remove the auxiliary brake reservoir from the
                                                                body but do not disconnect the hose; then route
  Rear Body Panel/Rack                                          and secure the hose and reservoir out of the way
                                                                making sure not to spill brake fluid.

REMOVING

 1. Remove the rear rack; then remove two cap screws
    securing the rear body panel/fender to the side
    frame and the cap screws securing the rear fenders
    to the footwells.




                                                                                                            KC306
                                                             4. Using a small screwdriver, remove the light con-
                                                                nectors from the frame; then disconnect both con-
                                                                nectors and remove the rear body panel/fender.



                                                   KC317A




                                                                                                                    8


                                                                                                            KC281




                                                    KC316
 2. Disconnect the battery (negative cable first) and
    remove from the battery compartment; then dis-
    connect the starter relay wires and route the wiring
    out of the compartment.




                                                                                                             8-9