mxu 400 Werkstatthandbuch : Seite 23

                              Lights

Rotate the ignition switch to the lights position; the
headlights and taillights should illuminate. Test the
brakelights by compressing the brake lever. The brake-
lights should illuminate.
HEADLIGHTS

  NOTE: The bulb portion of a headlight is fragile.
HANDLE WITH CARE. When replacing a headlight                                                              KC163A

bulb, do not touch the glass portion of the bulb. If       3. Remove the headlight bulb assembly from the
the glass is touched, it must be cleaned with a dry           headlight housing.
cloth before installing. Skin oil residue on the bulb
                                                           4. Install the new headlight bulb into the headlight
                                                                                                                    2
will shorten the life of the bulb.                            housing being careful not to get fingerprints or
                                                              other contaminates on the glass; then secure with
                ! WARNING                                     the spring.
Do not attempt to remove a bulb when it is hot.
Severe burns may result.

To replace the headlight bulb, use the following proce-
dure.
 1. Remove the protective rubber boot from the rear
    of the headlight housing; then remove the wiring
    harness connector from the back of the headlight
    bulb.



                                                                                                          KC163B
                                                           5. Connect the wiring harness connector to the bulb;
                                                              then install the protective rubber boot making sure
                                                              it seals completely on the headlight harness.




                                                KC146A




                                                                                                            KC146


                                                          TAILLIGHTS-BRAKELIGHTS

                                                          To replace a taillight-brakelight bulb, use the follow-
                                                          ing procedure.
                                                  KC162
                                                           1. Turn the bulb socket assembly counterclockwise
 2. Press in and release the spring retainer and pull         and remove from the housing.
    rearward clear of the bulb assembly.


                                                                                                            2-13