mxu 400 Werkstatthandbuch : Seite 24

                                                                      CHECKING/ADJUSTING
                                                            HEADLIGHT AIM

                                                            The headlights can be adjusted vertically and horizon-
                                                            tally. The geometric center of the HIGH beam light
                                                            zone is to be used for vertical and horizontal aiming.
                                                             1. Position the ATV on a level floor so the headlights
                                                                are approximately 6.1 m (20 ft) from an aiming
                                                                surface (wall or similar aiming surface).



                                                   KC157
 2. Press in and turn the bulb counterclockwise to
    remove. Press in and turn clockwise to install the
    bulb.
 3. Insert the bulb socket assembly into the housing
    and turn it clockwise to secure.
RUNNING LIGHTS/BACK-UP
LIGHTS

The running lights are located outboard of the head-                                                       ATV-0070C

lights, and the back-up lights are outboard of the tail-      NOTE: There should be an average operating
lights/brakelights. To replace the bulbs, use the           load on the ATV when adjusting the headlight aim.
following procedure.
 1. Rotate the bulb socket counterclockwise to release       2. Measure the distance from the floor to the
    from light housing; then press in on the bulb and           mid-point of each headlight.
    turn counterclockwise to release from the socket.        3. Using the measurements obtained in step 2, make
                                                                horizontal marks on the aiming surface.
                                                             4. Make vertical marks which intersect the horizontal
                                                                marks on the aiming surface directly in front of the
                                                                headlights.
                                                             5. Switch on the lights. Make sure the HIGH beam is
                                                                on. DO NOT USE LOW BEAM.
                                                             6. Observe each headlight beam aim. Proper aim is
                                                                when the most intense beam is centered on the ver-
                                                                tical mark 5 cm (2 in.) below the horizontal mark
                                                                on the aiming surface.

                                                  KC158A
                                                             7. Adjust each headlight by turning the adjuster knob
                                                                counterclockwise to raise the beam or clockwise to
 2. Install a new bulb and press in rotating clockwise          lower the beam.
    to secure; then place the socket into the light hous-
    ing and turn clockwise to secure.




                                                                                                            KC0108A
                                                  KC158B

2-14