14. FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM ATV 300/250
Nuts Cotter Pin
FRONT WHEEL HUB
REMOVAL AND INSPECTION
Place the machine on a level place.
Remove the front wheel (page 14-3) and
caliper. (page 13-8)
Elevate the front wheels by placing a
suitable stand under the frame.
Support the machine securely so
there is no danger of it falling over.
Remove the cotter pin.
Remove nut attaching the front wheel hub Outside Collar Dust Seal
and then remove front wheel hub.
DISASSEMBLY
Remove the outside collars.
Inspect the dust seals for wear or damage.
If any defects are found, replace the dust
seal with a new one.
Remove the dust seals by a flat-head screw
driver.
Place a wood block against the outer
edge to protect this edge. Outside Collar Dust Seal
Inspect the bearings for allow play in the Bearing
front wheel hub or the wheel turns roughly.
14-4
Sehr seriöser Verkäufer, zu empfehlen 
4.7 / 5