13. STEERINGHANDLEBAR/FRONTWHEEL/FRONT
BRAKE/FRONTSHOCKABSORBER/FRONTFORK
Pack all bearing cavities with grease. Driver Handle A
Drive in the left bearing.
Install the distance collar.
Drive in the right bearing.
· Do not allow the bearings to tilt while
driving them in.
· Drive in the bearing squarely with the
sealed end facing out.
Special Tools
Outer driver, 32x35mm
Driver handle A Outer Driver, 32x35mm Pilot, 12mm
Pilot, 12mm
Speedometer Gear Unit
INSTALLATION
Apply grease to the speedometer gear unit.
Install the speedometer gear unit by aligning
its retaining pawl with the hub cutout.
· If not aligned, the retaining pawl will
be deformed when the axle nut is
tightened.
· After installing the axle, turn the wheel
to make sure that the speedometer drive
shaft rotates freely.
Hub Cutout Pawl
Tab
Install the front wheel by aligning the
speedometer gear unit groove with the front
shock absorber tab.
Insert the axle and tighten the axle nut.
When installing the front wheel, position
the brake disk between the two brake
pads.
Torque: 4.55.0kg-m
Speedometer Gear Unit Groove
13-7
4.7 / 5