3. INSPECTION/ADJUSTMENT ATV 300/250 Rod Standard/Phillips Screwdriver DRIVE SELECT LEVER ADJUSTMENT Turn the ignition switch is ON and make sure the engine stop switch in the OFF position. Loosen the lock nuts of rod. Shift the gear to neutral by moving the shift lever and/or turn the rod. (The neutral indicator lamp comes on.) Provide standard/phillips screwdriver and pass the standard/phillips screwdriver Lock Nuts Shift Arm Index Hole through the shift arm into the index hole at the transmission case cover. Turn the rod clockwise or counterclockwise until the drive select lever into the "N" position of the shift guide and tighten the lock nuts, then pull out the standard/phillips screwdriver. After adjustment, start the engine and test to ride the ATV to be sure the drive select lever is operating properly. Rod Drive Lever 3-18