kxr maxxer 250 300 Werkstatthandbuch : Seite 59

          3. INSPECTION/ADJUSTMENT                                                  ATV 300/250

                                                          Maximum Mark    Minimum Mark
 COOLING SYSTEM
COOLANT LEVEL INSPECTION
Place the machine on the level ground.
Check the coolant level in the coolant
reservoir when the engine is cold as the
coolant level will vary with engine
temperature. The coolant level should be
between the maximum and minimum marks.
If the level is low, remove the coolant
reservoir cap, and then add coolant or
distilled water to raise it to the specified
level.                                            Coolant Reservoir Cap
Recommended Coolant: SIGMA Coolant
             (Standard Concentration 30%)
 The coolant level does not change no
   matter the engine is warm or cold. Fill to
   the maximum mark.

 COOLANT REPLACEMENT
 Perform this operation when the engine                                   Radiator Cap
    is cold.

 Remove the front fender. (page 2-5)
 Remove the radiator cap.
 Remove the drain bolt to drain the coolant.
 Drain the coolant in the reserve tank.
 Reinstall the drain bolt.
 The coolant freezing point should be 5
    °C lower than the temprature of the
    riding area.

 Coolant capacity:
                1.4 L (1.23 lmp qt, 1.48 US qt)
 Radiator capacity:
                1.1 L (0.97 lmp qt, 1.17 US qt)
 Reserve tank capacity:
                0.3 L (0.26 lmp qt, 0.32 US qt)
 Start the engine and check if there are no
 bubbles in the coolant and the coolant level
 is stable. Reinstall the radiator cap.
 If there are bubbles in the coolant, bleed air
 from the system.
 Fill the reserve tank with the recommended
 coolant up to the maximum mark.                  Drain Bolt




                                                                                  3-20