1. Kymco
  2. Werkstatthandbuch
  3. mxu 550 exi Werkstatthandbuch
  4. Seite 148

mxu 550 exi Werkstatthandbuch : Seite 148

Microfiches
Image preview

Seite 146

Image preview

Seite 147

Image preview
Image preview

Seite 149

Image preview

Seite 150

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 410 415 420 422 
          6. COOLING SYSTEM                                                  MXU 550EXi/MXU500i


 WATER TEMPERATURE                             Water Temperature Sensor
 SENSOR

 Remove the right side body cover and right
 footboard (refer to the "FRAME
 COVERS" section in the chapter 2).

 Disconnect the water temperature sensor
 connector.
 Remove the water temperature sensor from
 the water joint.


                                                                          Water joint
 INSPECTION
 Connect the water temperature sensor to the
 ohmmeter. Attached the standard resistance
 list as bellow then check it.
  Temperature        Standard resistance
   -20C/-4F               28.6K
   40C/104F               1.46K 
   20C/68F             3.51 K10%
  100°C/212°F            0.176 K




 After the water temperature sensor has been
 installed, fill coolant and perform air
 bleeding (refer to the "COOLANT
 REPLACEMENT" section in this
 chapter).

 INSTALLATION

 With thread lock applied to the threaded
 part, tighten the water temperature sensor.

 Torque: 0.8 kgf-m (8 N-m, 5.8 lbf-ft)




6-17
 Microfiches.net - Ersatzteilkataloge anderer Marken